![]() I have not been able to figure out how to disable the automatic brightness adjustment (never liked that feature), but for now I just covered the sensor with some black electrical tape and it no longer attempts to change the brightness on me. I can adjust the volume with the keyboard keys as well as from Monitor Control and it shows the changes in the Monitor's own controls. I'm running macOS Monterey 12.0.1 and Monitor Control 4.0.2 Build 6965 and my monitor is a Dell U3415W. The controls will not work in control center or system preferences, but brightness can be adjusted through MonitorControl or shortcut keys. Updated MonitorControl to the latest version (if applicable) Describe the bug. Once installed I had to set the DDC max for brightness to 255 and it now behaves as before. I found a discussion on Reddit (linked below) describing the same issue, which ultimately led to installing an app called MonitorControl. It seems the display is no longer supported under Monterey and ability to control display brightness and automatic brightness adjustment have gone away. Optional Rack Kit: SRC (Source Rack Kit), $49.I had this same issue with my M1 MacBook Air and a 27" LED Cinema Display. ![]() Power Supply: 12 volt, 2 Amp (Part number PSU-SRC) The AES inputs lock from 32kHz to 192kHz sample rates with the following: 103dB The headphone amp can easily drive several sets of cans.ĭimensions: 12 3/4″ Wide x 8″ Deep x 1 5/8″ High Volume knobs track better than +- 0.5dB from unity to -40dB. The meter and speakers outputs are fully balanced and 600 ohm drive capable to >+26dBu. Input 2 to selected line out and Speakers:įrequency Response : +0, -0.5dB from 80 kHz Input 1 to Selected Line Out and Speakers:įrequency Response: +0, -0.5dB from 80 kHz ![]() I tried MonitorControl, but while it detected both monitors with separate. Whatever’s needed, wherever you are, the SOURCE will deliver! My setup is a 2013 MacBook Pro with Mojave, connected to two relatively new. Return to “toggle” mode and easily let the singer hear their own personal headphone mix from an analog input while you engineer the real mix from the USB. Better handling of virtual screens (AirPlay, Sidecar). For example, set the speaker switches to “latch” and use the second speaker output as a switchable subwoofer out – or perhaps to provide simultaneous live-room monitoring, or to just blast both sets of speakers at once! Set the input switches to “latch” and you can jam along with your portable devices, or otherwise creatively layer multiple input sources. MonitorControl now disengages from media keys when there is no external display connected. By switching the input and output sections between “toggle” mode (one at a time) and “latch” mode (simultaneously activated), you can layer sounds and double-up the inputs in creative and very useful ways. The two onboard reference-grade D/A converters deliver every last detail of your music, while the robust, crystal clear headphone amplifier and two speaker outputs round out the SOURCE’s incredibly versatile signal paths.Īny input and speaker outputs can be used individually or simultaneously for all sorts of studio solutions. Use the Selected Line output to feed an external meter, recording device, club PA system or even for creative re-amping setups. The Selected Line output provides an analog mirror of whatever you’re monitoring in the control room, bypassing the main volume control. Digital inputs include both USB (for Windows and Mac) and AES/SPDIF up to 192khz, and the AES/SPDIF has a very useful thru-port, allowing you to capture or monitor that signal outside the SOURCE any way you see fit. As the centerpiece to your studio, the SOURCE is equipped with a balanced stereo professional level analog input on XLR/TRS jacks and an 1/8” stereo commercial level input for iPhones, laptops and other devices.
0 Comments
Leave a Reply. |